Sylvania Stereo System SRCD5670 User Manual

SRCD5670 English (371 x 210mm) 17 July 2010 /L  
Before using the unit, be sure to read all operating instructions  
carefully. Please note that these are general precautions and may  
not pertain to your unit. For example, this unit may not have the  
capability to be connected to an outdoor antenna.  
1. Read these instructions.  
All the safety and operating instructions should be read before  
the product is operated.  
2. Keep these instructions.  
The safety and operating instructions should be retained for  
future reference.  
3. Heed all warnings.  
All warnings on the product and in the operating instructions  
should be adhered to.  
4. Follow all instructions.  
14. Refer all servicing to qualified service personnel. Servicing  
is required when the apparatus has been damaged in any  
way, such as power-supply cord or plug is damaged, liquid  
has been spilled or objects have fallen into the apparatus, the  
apparatus has been exposed to rain or moisture does not  
operate normally, or has been dropped.  
24. Damage requiring service.  
Unplug this product from the wall outlet and refer service to  
qualified service personnel under the following conditions.  
a) When the power-supply cord or plug is damaged.  
b) If liquid has been spilled or objects have fallen into the  
product.  
c) If the product has been exposed to rain or water.  
d) If the product does not operate normally by following the  
operating instructions.  
Adjust only those controls that are covered by the  
operating instructions, as an adjustment of other controls  
may result in damage and will and require extensive work  
by a qualified technician to restore in the product to its  
normal operation.  
SAFETY INSTRUCTION  
CAUTION  
15. Power source.  
RIKS OF ELECTRIC  
SHOCK  
This product should be operated only from the type of power  
source indicated on the marking label. If you are not sure of the  
type of power supply to your home, consult your appliance  
dealer or local power company. For products intended to operate  
from battery power, or other source, refer to the operation  
instructions.  
DO NOT OPEN  
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO  
NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE  
PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE  
PERSONNEL.  
16. Power lines.  
All operating and use instructions should be followed.  
5. Do not use this apparatus near water.  
An outside antenna system should not be located in the vicinity  
of overhead power lines or other electric light or power circuits,  
or where it can fall into such power lines or circuits. When  
installing an outside antenna system, extreme care should be  
taken to keep from touching such power lines or circuits as  
contact with them might be fatal.  
e) If the product has been dropped or the cabinet has been  
damaged.  
f) When the product exhibits a distinct change in  
performance-this indicates a need for service.  
25. Note to CATV system installer.  
DANGEROUS VOLTAGE:  
The lightning flash with arrowhead symbol, within  
an equilateral triangle is intended to alert the user  
to the presence of uninsulated dangerous voltage  
within the products enclosure that may be of  
sufficient magnitude to constitute a risk of electric  
shock to persons.  
Do not use this product near water and moisture, for example:  
near a bathtub, washbowl, kitchen sink or laundry tub; in a wet  
basement; or near a swimming pool.  
6. Clean only with dry cloth.  
Micro System CD Player  
with Clock Radio  
Unplug this product from the wall outlet before cleaning. Do  
not use liquid cleaners or aerosol cleaners. Use a dry cloth for  
cleaning.  
17. Overloading.  
This reminder is provided to call the CATV system  
installer's attention to Article 820-40 of the NEC that  
provides guidelines for proper grounding and, in particular,  
specifies that the cable ground shall be connected to the  
grounding system of the building, as close to the point of  
cable entry as practical.  
Do not overload wall outlets and extension cords as this can  
result in a risk of fire or electric shock.  
18. Object and liquid entry.  
ATTENTION:  
The exclamation point within an equilateral triangle  
is intended to alert the user to the presence of  
important operating and maintenance (servicing)  
instructions in the literature accompanying the  
appliance.  
7. Do not block any ventilation openings. Install in accordance  
with the manufacturer's instructions.  
Never push objects of any kind into this product through  
openings as they may touch dangerous voltage points or short  
out parts that could result in fire or electric shock. Never spill  
or spray any type of liquid on the product.  
MODEL: SRCD5670  
Slots and openings in the cabinet and in the back or bottom are  
provided for ventilation, to ensure reliable operation of the  
product and to protect it from overheating. These openings must  
not be blocked or covered. The openings should never be  
blocked by placing the product on a bed, sofa, rug or other  
similar surface. This product should never be placed near or over  
a radiator or heat source. This product should not be placed in a  
built-in installation such as a bookcase or rack unless proper  
ventilation is provided or the manufacturer's instructions have  
been adhered to.  
DANGER:  
NOTE: Refer all servicing to qualified service personnel.  
Servicing is required when the unit has been damaged in any way  
such as the following: the power-supply cored or plug has been  
damaged, liquid has been spilled into the unit, the unit has been  
exposed to rain or moisture, the unit has been dropped or the unit  
does not operate normally.  
19. Outdoor antenna grounding.  
Invisible and hazardous laser radiation when open  
and interlock failed or defeated. Avoid direct  
exposure to beam.  
If an outside antenna is connected to the product, be sure the  
antenna system is grounded so as to provide some protection  
against voltage surges and built up static charges. Section 810  
of the National Electric Code ANSI/NFPA 70 provides  
information with respect to proper to grounding of the mast and  
supporting structure, grounding of the lead-in wire to an antenna  
discharge product, size of grounding conductors, location of  
antenna-discharge product, connection to grounding electrodes  
and requirements for the grounding electrodes.  
20. Service.  
LASER SAFETY: This unit employs a laser. Only qualified service  
personnel should attempt to service this device due to possible eye  
injury.  
CAUTION: USE OF CONTROLS, ADJUSTMENTS OR  
PERFORMANCE PROCEDURE HEREIN MAY RESULT IN  
HAZARDOUS RADIATION EXPOSURE.  
8. Do not install near any heat sources such as radiators, heat  
registers, stoves, or other apparatus (including amplifiers)  
that produce heat.  
9. Do not defeat the safety purpose of the polarized or  
grounding-type plug. A polarized plug has two blades with  
one wider than the other. A grounding type plug has two  
blades and a third grounding prong. The wide blade or the  
third prong are provided for your safety. If the provided plug  
does not fit into your outlet, consult an electrician for  
replacement of the obsolete outlet.  
10. Protect the power cord from being walked on or pinched  
particularly at plugs,  
convenience receptacles, and the point where they exit from  
the apparatus.  
11. Only use attachments/accessories specified by the  
manufacturer.  
SURGE PROTECTORS:  
Do not attempt to service  
It is recommended to use a surge protector for AC connection.  
Lightning and power surges ARE NOT covered under warranty  
for this product.  
ANTENNA LEAD IN WIRE  
this product yourself as  
GROUND CLAMP  
opening or removing  
ANTENNA DISCHARGE  
UNIT  
(NEC SECTION 810-20)  
covers may expose you  
ELECTRIC SERVICE  
FCC WARNING:  
EQUIPMENT  
to dangerous voltage or  
GROUNDING CONDUCTOR  
This equipment may generate or use radio frequency energy. Changes  
or modifications to this equipment may cause harmful interference  
unless the modifications are expressly approved in the instruction  
manual. The user could lose the authority to operate this equipment  
if an unauthorized change or modification is made.  
(NEC SECTION 810-21)  
other hazards. Refer all  
servicing to qualified  
GROUND CLAMPS  
POWER SERVICE GROUNDING  
service personnel.  
ELECTRODE SYSTEM  
(NEC ART 250, PART H)  
21. Replacement parts.  
When replacement parts aEreXAreMqPuNLiAErTeOIdOF,NAbANeLTEsENuLNEreCATtGRhRIeCOAsUeLNrCDvOIiNcDGeEAS PER  
technician uses replacement parts specified by the manufacturer  
or those that have the same characteristics as the original parts.  
Unauthorized substitutions may result in fire or electric shock  
or other hazards.  
INFORMATION:  
This equipment has been tested and found to comply with the limits  
for a Class B digital device, pursuant to Part 15 of the FCC Rules.  
These limits are designed to provide reasonable protection against  
harmful interference in a residential installation. This equipment  
generates, uses and can radiate radio frequency energy and, if not  
installed and used in accordance with the instructions, may cause  
harmful interference to radio communications. However, there is  
no guarantee that interference will not occur in a particular installation.  
If this equipment does cause harmful interference to radio or television  
reception, which can be determined by turning the equipment off  
and on, the user is encouraged to try to correct the interference by  
one or more of the following measures:  
PORTABLE CART WARNING  
(symbol provided by RETAC)  
12. Use only with the cart, stand, tripod,  
bracket, or table specified by the  
manufacturer, or sold with the apparatus.  
When a cart is used, use caution when  
moving the cart/ apparatus combination  
22. Safety check.  
Upon completion of any service or repairs to this product, ask  
the service technician to perform safety checks to determine  
that the product is in proper operation condition.  
23. Wall or ceiling mounting.  
INSTRUCTION MANUAL  
Operating Instructions  
to avoid injury from tip-over  
An appliance and cart combination should be  
moved with care. Quick stops, excessive force and uneven  
surfaces may cause the appliance and cart combination to  
overturn.  
The product should be mounted to a wall or ceiling only as  
recommended by the manufacturer.  
Reorient or relocate the receiving antenna.  
13. Unplug this apparatus during lightning storms or when  
unused for long periods of time. To protect your product from  
a lightning storm, or when it is left unattended and unused for  
long periods of time, unplug it from the wall outlet and  
disconnect the antenna or cable system. This will prevent  
damage to the product due to lightning and power-line surges.  
Increase the separation between the equipment and receiver.  
Connect the equipment into an outlet on a circuit different from  
that to which the  
receiver is connected.  
Consult the dealer or an experienced radio/TV technician for help.  
READ THIS INSTRUCTION MANUAL BEFORE  
CONNECTING OR OPERATING THIS  
APPLIANCE. SAVE THIS INSTRUCTION  
MANUAL FOR FUTURE REFERENCE.  
 

Sharp Microwave Oven R 982STM User Manual
Shop Vac Vacuum Cleaner LB650C User Manual
Singer Sewing Machine 114 38 User Manual
Soleus Air Dehumidifier SG DEH 70EIP 6 User Manual
Sony CRT Television KV G142M User Manual
Sony DVD VCR Combo RDR VX500 User Manual
Sony Portable Speaker SRS PC71 User Manual
Sony Speaker SS MB100H User Manual
Stanley Black Decker Power Hammer MB656 User Manual
Sunbeam Blender 250 22 User Manual