Soleus Air Electric Heater HM4 15R 01 User Manual

Flat Panel Micathermic  
Heater with  
Remote Control  
OWNER’S MANUAL  
Model # HM4-15R-01  
PLEASE SAVE THESE INSTRUCTIONS  
WARNING: READ THIS OWNER’S MANUAL CAREFULLY BEFORE USE.  
 
NOT use on soft surfaces, like a bed, where openings may become blocked.  
12. A heater has hot and arcing or sparking parts inside. DO NOT use in areas where  
gasoline, paint, explosive and/or flammable liquids are used or stored. Keep unit away  
from heated surfaces and open flames.  
13. Avoid the use of an extension cord because the extension cord may overheat and cause a  
risk of fire. However, if you have to use an extension cord, the cord shall be No. 16  
AWG minimum size and rated not less than 1500W.  
14. To avoid fire or shock hazard, plug the unit directly into a 115 V AC electrical outlet.  
15. To disconnect heater, turn controls to OFF, then remove plug from outlet. Pull firmly on  
the plug, DO NOT unplug by pulling on the cord.  
16. Always unplug the unit before moving or cleaning, or whenever the heater is not in use.  
17. Use only for intended household use as described in this manual. Any other use not  
recommended by the manufacturer may cause fire, electric shock, or injury to persons.  
The use of attachments not recommended or sold by unauthorized dealers may cause  
hazards.  
18. Always use on a dry, level surface. Use on floor only.  
19. DO NOT use outdoors.  
20. WARNING: To reduce the risk of fire or electric shock, DO NOT use this unit with any  
solid-state speed control device.  
21. DO NOT attempt to repair or adjust any electrical or mechanical functions on this unit.  
Doing so will void your warranty. The inside of the unit contains no user serviceable  
parts. Qualified personnel should perform all servicing only.  
22. Connect to properly grounded outlets only.  
23.SAVE THESE INSTRUCTIONS.  
WARNING: This heater has a voltage rating of  
120 volts. The cord has a plug as shown in A. An  
adapter as shown in C is available for connecting  
three-blade grounding-type plugs to two-slot  
receptacles. The grounding lug extending from  
the adapter must be connected to a permanent  
ground such as a properly grounded outlet box.  
The adapter should not be used if a three-slot  
grounded receptacle is available.  
DO NOT DEFEAT THE SAFETY PURPOSE  
OF THE GROUNDED PLUG.  
3
 
SPECIFICATIONS  
Voltage Rating  
Power Consumption  
Unit Size  
120 V (60Hz)  
750/1500W  
18 in. (W) x 8 5/8 in. (D) x 26 in. (H)  
11 lbs  
Unit Weight  
PRODUCT DIAGRAM  
Carrying Handle  
Control Panel  
Wheel Base  
Wheel  
Remote Control  
4
 
ASSEMBLY  
1. Remove the heater body, two wheelbases, wheels, screws, and washers from the box.  
Remove the packaging materials and keep for future storage.  
2. Attach the wheels to each wheelbase with the supplied wheel screws, small black spring-  
washers, and small grey washers.  
Wheel Screw  
Wheel  
Small Black Spring-Washer  
Small Grey Washer  
Wheel Base  
3. Be certain the heater is unplugged and the controls are set to off. Set the heater on the  
floor upside down.  
4. Attach a wheel base (with wheels attached) to each end of the heater body using the  
supplied standard screws, large black spring-washers, and large grey washers.  
Standard Screw  
Large Black Spring-Washer  
Large Grey Washer  
Wheel Base  
Heater Body  
5
 
OPERATING INSTRUCTIONS  
Place the heater on a firm, level surface and plug into a grounded 120V 60Hz power outlet. Only  
operate heater in upright position with caster wheels attached.  
Temperature Display  
Receiver for Remote Control  
Timer Button  
Temperature Buttons  
Indication Lights  
Mode Select Button  
On/Off Button  
1. Turn the heater on by pressing the On/Off button on the control panel or the supplied  
remote control.  
2. Select a heat setting.  
Press the MODE button to toggle between the three heat settings; LOW (500W), HIGH  
(1000W) and ECO mode. When using the remote control press either MODE button to  
select the preferred power setting.  
NOTE: ECO mode is an Economic Energy Saving Function. When ECO mode is chosen the  
heater will consume one-third less power once the room temperature reaches a certain point.  
3. Adjust the thermostat by pressing the arrows on the control panel or remote control. The  
digital readout will display the selected temperature.  
4. Once you have chosen the desired temperature, the heater will remain on until the room  
temperature increases to the temperature on the digital display. The heater will cycle on  
and off to maintain the desired room temperature.  
5. This heater is equipped with a 12-hour automatic shut-off timer. To activate the timer,  
press the TIMER button on the control panel or remote control. Each press of the timer  
button will increase the heater operating time by one hour. The digital readout will  
display the number of hours you have selected. To turn off the timer, simply press the  
TIMER button until the digital readout displays your current selected temperature.  
6
 
6. The indication lights on the control panel communicate how the product is operating.  
The POWER light will turn-on when the unit is operating. The TIMER light will turn on  
when the timer has been activated. When choosing between High, Low, and ECO modes  
the corresponding lights will turn on according to the mode that has been selected.  
7. Unplug the heater when not in use.  
NOTE: For safety, if the heater’s internal temperature rises above a certain point, the heater  
is designed to automatically shut off. To restart the heater in this situation:  
1. Turn the Heater off by pressing the On/Off button.  
2. Unplug the power cord from the outlet and allow the heater to cool for at least 10  
minutes.  
3. Plug the power cord back into the outlet and select the desired heat setting.  
WARNING: It is normal for the power cord to feel warm to the touch; however, a loose fit  
between the outlet and the plug may cause overheating of the plug. If this occurs, try inserting  
the plug into a different outlet. Contact a qualified electrician to inspect the original outlet for  
damage.  
7
 
MAINTENANCE  
1. Unplug the unit and let it cool completely.  
2. To keep the heater clean, the outer shell may be cleaned with a soft, damp cloth. You  
may use a mild detergent if necessary. After cleaning, dry the unit with a soft cloth.  
CAUTION: DO NOT let liquid enter the heater.  
3. DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes to  
clean the heater. This may cause damage or deterioration to the surface of the heater.  
4. DO NOT immerse the heater in water.  
5. Wait until the unit is completely dry before use.  
STORAGE  
Store the heater in a cool, dry location when not in use. To prevent dust and dirt build-up, use the  
original packaging to repack the unit.  
TROUBLESHOOTING  
If the heater will not operate, please check the following before seeking repair of service:  
1. Check if the power cord is plugged into an electrical outlet, if not, plug in.  
2. Check if electricity to the main fuse is working.  
3. Make certain the unit is turned on, and either the HIGH or LOW heat setting is selected.  
If not, turn the heater on and choose a setting.  
NOTE: The heater may not be operating if the thermostat is set higher than the room  
temperature. To begin operation, increase the thermostat temperature for a higher heat  
setting.  
8
 
WARRANTY  
One Year Limited Warranty  
Soleus International Inc. warrants the accompanying Soleus Air HM4-15R-01 to be free of defects in  
material and workmanship for the applications specified in its operation instruction for a period of ONE  
(1) year from the date of original retail purchase in the United States.  
If the unit exhibits a defect in normal use, Soleus International Inc. will, at its option, either repair or  
replace it, free of charge within a reasonable time after the unit is returned during the warranty period.  
As a condition to any warranty service obligation, the consumer must present this Warranty Certificate  
along with a copy of the original purchase invoice.  
THIS WARRANTY DOES NOT COVER:  
1) Damage, accidental or otherwise, to the unit while in the possession of a consumer not caused by  
a defect in material or workmanship.  
2) Damage caused by consumer misuse, tampering, or failure to follow the care and special handling  
provisions in the instructions.  
3) Damage to the finish of the case, or other appearance parts caused by wear.  
4) Damage caused by repairs or alterations of the unit by anyone other than those authorized by  
Soleus International Inc.  
5) Freight and Insurance cost for the warranty service.  
ALL WARRANTIES, INCLUDING ANY IMPLIED WARRANTY OF MERCHANT ABILITY ARE  
LIMITED TO ONE-YEAR DURATION OF THIS EXPRESS LIMITED WARRANTY. SOLEUS  
INTERNATIONAL INC. DISCLAIMS ANY LIABILITY FOR CONSEQUENTIAL OR  
INCIDENTAL DAMAGES AND IN NO EVENT SHALL SOLEUS INTERNATIONAL INC’S  
LIABILITY EXCEED THE RETAIL VALUE OF THE UNIT FOR BREACH OF ANY WRITTEN OR  
IMPLIED WARRANTY WITH RESPECT TO THIS UNIT.  
This warranty covers only new products purchased from our authorized dealers or retailers. It does not  
cover used, salvaged, or refurbished products.  
As some states do not allow the limitation or exclusion of incidental or consequential damages, or do not  
allow limitation on implied warranties, the above limitations and exclusions may not apply to you. This  
warranty gives you specific legal rights, and you may also have other rights that vary from state to state.  
For Technical Support and Warranty Service  
Please Call (888) 876-5387  
Or Write To:  
Soleus International Inc.  
9451 Telstar Ave.  
El Monte, CA 91731 USA  
9
 

Sennheiser Wireless Office Headset SD PRO 1 ML User Manual
Shark Vacuum Cleaner S1209 User Manual
Sharp All in One Printer AR 237M User Manual
Sharp CRT Television LC 40LE812E User Manual
Sharp Flat Panel Television PN R603 User Manual
Sony Camera Lens ECMALST1 User Manual
Sony Flat Panel Television XBR 55X850A User Manual
Sony Portable CD Player D EJ106CK User Manual
Sunbeam Slow Cooker HP2200 User Manual
Tanita Computer Monitor BC 532 User Manual